end
Exits the current configuration mode and returns to the Exec mode.
Product
All
Privilege
Security Administrator, Administrator
Syntax
end
Usage Guidelines
Use this command to return to the Exec mode.
The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.
Important |
In Release 20, 21.0 and 21.1, HeNBGW is not supported. Commands in this configuration mode must not be used in these releases. For more information, contact your Cisco account representative. |
The MME Pool configuration is used to configure one or more MMEs to which the HeNB-GW is to communicate. This configuration is available under lte-policy configuration mode. Adding or modifying an MME pool instance puts the user into the MME Pool configuration mode.
Exec > Global Configuration > LTE Policy Configuration > HeNBGW MME Pool Configuration
configure > lte-policy > henbgw mme-pool mme_pool_name
Entering the above command sequence results in the following prompt:
[local]host_name(mme-pool)#
Important |
The commands or keywords/variables that are available are dependent on platform type, product version, and installed license(s). |
Exits the current configuration mode and returns to the Exec mode.
All
Security Administrator, Administrator
end
Use this command to return to the Exec mode.
Exits the current mode and returns to the parent configuration mode.
All
Security Administrator, Administrator
exit
Use this command to return to the parent configuration mode.
Configures a specific MME to HeNBGW.
HeNB-GW
Administrator
Exec > Global Configuration > LTE Policy Configuration > HeNBGW MME Pool Configuration
configure > lte-policy > henbgw mme-pool mme_pool_name
Entering the above command sequence results in the following prompt:
[local]host_name(mme-pool)#
[ no ] mme mme_name { ipv4-address ipv4_address [ ipv4-address ipv4_address ] | ipv6-address ipv6_address [ ipv6-address ipv6_address ] [ sctp port port_val ] }
Removes the configured MME to HeNBGW.
Specifies the MME name as an alphanumeric string of size 1 through 63 characters.
Specifies the remote SCTP IPv4 Address for S1 association to MME. ipv4_address is specified using a dotted-decimal notation.
Specifies the remote SCTP IPv6 Address for S1 association to MME. ipv6_address is specified using a colon-separated hexadecimal notation.
Configures the S1-MME SCTP parameters.
Designates the SCTP port.
port_val is an integer ranging from 1 through 65535.
Use this command to configure a specific MME to HeNBGW.
mme mme1 ipv4-address 10.0.0.1 sctp port 302