|
Command or Action |
Purpose |
|
enable
Example:
Router> enable
|
Enables privileged EXEC mode.
-
Enter your password if prompted.
|
|
configure terminal
Example:
Router# configure terminal
|
Enters global configuration mode. |
|
hostname name
Example:
Router(config)# hostname cust1-53a
|
Specifies the hostname for the network server. |
|
aaa new-model
Example:
Router(config)# aaa new-model
|
Enables the AAA server. |
|
aaa authentication ppp {default | list-name} method1 [method2...]
Example:
Router(config)# aaa authentication ppp default if-needed group radius
|
Specifies one or more AAA authentication methods for use on serial interfaces that are running PPP. |
|
aaa authorization configuration default {radius | tacacs+
Example:
Router(config)# aaa authorization configuration default radius
|
Downloads configuration information from the AAA server. |
|
show ipv6 route [ipv6-address | ipv6-prefix / prefix-length | protocol | interface-type interface-number
Example:
Router(config)# show ipv6 route
|
Shows the routes installed by the previous commands. |
|
virtual-profile virtual-template number
Example:
Router(config)# virtual-profile virtual-template 1
|
Enables virtual profiles by virtual interface template. |
|
interface serial controller-number : timeslot
Example:
Router(config)# interface serial 0:15
|
Specifies a serial interface created on a channelized E1 or channelized T1 controller (for ISDN PRI, channel-associated signaling, or robbed-bit signaling). This command also puts the router into interface configuration mode. |
|
encapsulation encapsulation-type
Example:
Router(config-if)# encapsulation ppp
|
Sets the encapsulation method used by the interface. |
|
exit
Example:
Router(config-if)# exit
|
Returns to global configuration mode. |
|
dialer-group group-number
Example:
Router(config)# dialer-group 1
|
Controls access by configuring an interface to belong to a specific dialing group. |
|
ppp authentication protocol1 [protocol2...] [if-needed] [list-name | default] [callin] [one-time] [optional]
Example:
Router(config)# ppp authentication chap
|
Enables Challenge Handshake Authentication Protocol (CHAP) or Password Authentication Protocol (PAP) or both and specifies the order in which CHAP and PAP authentication are selected on the interface. |
|
interface virtual-template number
Example:
Router(config)# interface virtual-template 1
|
Creates a virtual template interface that can be configured and applied dynamically in creating virtual access interfaces. |
|
ipv6 enable
Example:
Router(config)# ipv6 enable
|
Enables IPv6 processing on an interface that has not been configured with an explicit IPv6 address. |
|
dialer-list dialer-group protocol protocol-name {permit | deny | list access-list-number | access-group}
Example:
Router(config)# dialer-list 1 protocol ipv6 permit
|
Defines a dial-on-demand routing (DDR) dialer list for dialing by protocol or by a combination of a protocol and a previously defined access list. |
|
radius-server host {hostname | ip-address} [test username user-name] [auth-port port-number] [ignore-auth-port] [acct-port port-number] [ignore-acct-port] [timeout seconds] [retransmit retries] [key string] [alias {hostname | ip-address}] [idle-time seconds
Example:
Router(config)# radius-server host 172.17.250.8 auth-port 1812 acct-port 1813 key testing123
|
Specifies a RADIUS server host. |