Wall Mount Components for Cisco Unified IP Phone 6901
The following section describes how to install the Wall Mount plate for use with the Cisco Unified IP Phone 6901.
Cisco recommends that you use the Leviton Wall Mount plate (Leviton type number: 4108W-0SP) for mounting the Cisco Unified IP Phone 6901. The wall mount plate must be ordered separately from the phone.
The following figure and table show a list of items required to mount the Cisco Unified IP Phone 6901 on the wall using the Leviton Wall Mount plate.
1 |
RJ45 Connector |
2 |
Leviton Wall Mount Plate |
Install Phone on Wall Mount Plate
To install the phone on the wall mount plate, perform these steps:
Procedure
Step 1 |
Plug the telephone line cord (RJ45 connector) into the phone jack at the base of the phone.
|
||||||||
Step 2 |
Plug the RJ45 connector into the wall mount phone jack.
|
||||||||
Step 3 |
Slip the mounting holes on the base of the wall mount plate and over the wall mount pins.
|
||||||||
Step 4 |
Firmly slide the IP Phone down into place. |
||||||||
Step 5 |
Change the handset as described in Adjust Handset Rest. |