-
Cisco CallManager Administration Guide, Release 3.1(1)
-
Index
-
Preface
-
Introduction
-
Server Configuration
-
Cisco CallManager Configuration
-
Cisco CallManager Group Configuration
-
Date/Time Group Configuration
-
Device Defaults Configuration
-
Region Configuration
-
Device Pool Configuration
-
Enterprise Parameters Configuration
-
Location Configuration
-
Auto-Registration Configuration
-
Partition Configuration
-
Calling Search Space Configuration
-
Route Filter Configuration
-
Route Group Configuration
-
Route List Configuration
-
Route Pattern Configuration
-
Translation Pattern Configuration
-
External Route Plan Wizard
-
Special Characters and Settings
-
Route Plan Report
-
Cisco Messaging Interface Configuration
-
Cisco TFTP Configuration
-
Cisco WebAttendant Configuration
-
Conference Bridge Configuration
-
Media Termination Point Configuration
-
Music On Hold Configuration
-
Media Resource Group Configuration
-
Media Resource Group List Configuration
-
Service Parameters Configuration
-
Transcoder Configuration
-
Starting and Stopping Services
-
Call Park Configuration
-
Call Pickup and Group Call Pickup Configuration
-
Cisco IP Phone Services Configuration
-
Device Configuration
-
CTI Route Point Configuration
-
Cisco Voice Mail Configuration
-
Device Profile Configuration
-
Gatekeeper Configuration
-
Gateway Configuration
-
Cisco IP Phone Configuration
-
Phone Button Template Configuration
-
Adding a New User
-
Searching the Global Directory
-
Plugin Configuration
-
Cisco TAPI Service Provider Installation and Configuration
-
Cisco JTAPI Installation and Configuration
-
Personal Directory
-
Feedback
Table Of Contents
Region Configuration
Use regions to specify the voice codec used for calls within a region and between existing regions. The voice codec determines the type of compression and maximum amount of bandwidth used per call.
Note
The default voice codec for all calls through Cisco CallManager is G.711. If you do not plan to use any other voice codec, you do not need to use regions.
Use the following procedures to add, update, or delete regions:
•
Refer to the "Regions" section in the Cisco CallManager System Guide for more information about configuring regions and selecting voice codecs.
Adding a Region
This section describes how to add a new region to the Cisco CallManager database.
Procedure
Step 1
Step 2
Step 3
See Table 7-1 for a summary of the available codec types and bandwidth usage.
Before saving the changes, you can click Cancel Changes to reset all fields to original values.
Step 4
Next Step
After adding a new region to the database, you can use it to configure device pools. Devices acquire a region setting from the device pool to which they are assigned. See the "Adding a Device Pool" section for information on configuring device pools.
Related Topics
•
Updating a Region
This section describes how to update the configuration for a region.
Procedure
Step 1
Step 2
Update the codec settings for calls within the region and between other regions. See Table 7-1 for a summary of the available codec types and bandwidth usage.
Before saving the changes, you can click Cancel to reset all fields to original values.
Step 3
Step 4
Related Topics
•
Deleting a Region
This section describes how to delete a region from the Cisco CallManager database.
Before You Begin
You cannot delete a region that is being used by any device pools. If you try to delete a region that is in use, Cisco CallManager displays an error message. Before deleting a region that is currently in use, you must perform either or both of the following tasks:
•
•
Procedure
Step 1
Step 2
Step 3
Related Topics
•
Region Configuration Settings
Table 7-1 summarizes the available voice codecs that can be specified for regions. The total bandwidth used per call depends on the voice codec type as well as factors such as data packet size and overhead (packet header size). The bandwidth figures shown in Table 7-1 apply for 30-ms data packets and include IP headers.
Related Topics
