- A
- B
- cac master through call application stats
- call application voice through call denial
- call fallback through called-number (dial peer)
- caller-id (dial peer) through ccm-manager switchover-to-backup
- ccs connect (controller) through clear vsp statistics
- clid through credentials (sip-ua)
- default (auto-config application) through direct-inward-dial
- disable-early-media through dualtone
- E
- F
- G
- H
- icpif through irq global-request
- isdn bind-l3 through ixi transport http
- K
- L
- map q850-cause through mgcp package-capability
- mgcp persistent through mmoip aaa send-id secondary
- mode (ATM/T1/E1 controller) through mwi-server
- N
- O
- package through pattern
- periodic-report interval through proxy h323
- Q
- R
- sccp through service-type call-check
- session through sgcp tse payload
- show aal2 profile through show call filter match-list
- show call history fax through show debug condition
- show dial-peer through show gatekeeper zone prefix
- show gateway through show modem relay statistics
- show mrcp client session active through show sip dhcp
- show sip service through show trunk hdlc
- show vdev through show voice statistics memory-usage
- show voice trace through shutdown (voice-port)
- signal through srv version
- ss7 mtp2-variant through switchover method
- target carrier-id through timeout tsmax
- timeouts call-disconnect through timing clear-wait
- timing delay-duration through type (voice)
- U
- vad (dial peer) through voice-class sip encap clear-channel
- voice-class sip error-code-override through vxml version 2.0
- W
- Z
Cisco IOS Voice Commands:
W
This chapter contains commands to configure and maintain Cisco IOS voice applications. The commands are presented in alphabetical order. Some commands required for configuring voice may be found in other Cisco IOS command references. Use the command reference master index or search online to find these commands.
For detailed information on how to configure these applications and features, refer to the Cisco IOS Voice Configuration Guide.
watcher all
To allow an external watcher to monitor an internal presentity, use the watcher all command in presence configuration mode. To disable monitoring by external watchers, use the no form of this command.
watcher all
no watcher all
Syntax Description
This command has no arguments or keywords.
Command Default
Only internal watchers are allowed when presence is enabled.
Command Modes
Presence configuration (config-presence)
Command History
|
|
|
|---|---|
12.4(11)XJ |
This command was introduced. |
12.4(15)T |
This command was integrated into Cisco IOS Release 12.4(15)T. |
Usage Guidelines
This command allows external watchers on a remote router connected through a SIP trunk to monitor internal directory numbers. You must enable the allow watch command on the internal directory numbers that are watched. To allow external watching from the remote router, you must enable the allow subscribe command on the remote router.
Examples
The following example shows how to enable external watching of an internal presentity:
Router(config)# presence
Router(config-presence)# watcher all
Feedback