Weight and Power Consumption
For information on physical specifications and power consumption, refer to the following data sheets:
The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.
This chapter describes the system specifications for Cisco NCS 5700 router.
For information on physical specifications and power consumption, refer to the following data sheets:
For information on environmental specifications, see table Environmental properties in the following data sheets:
The RJ-45 connector connects Category 3, Category 5, Category 5e, Category 6, or Category 6A foil twisted-pair or unshielded twisted-pair cable from the external network to the following module interface connectors:
Router chassis
CONSOLE port
MGMT ETH port
Caution |
To comply with GR-1089 intrabuilding, lightning immunity requirements, you must use a foil twisted-pair (FTP) cable that is properly grounded at both ends. |
The following figure shows the RJ-45 connector.
1 |
Pin 1 |
2 |
Pin 2 |
The following table summarizes the Management Ethernet port pinouts.
Pin |
Signal Name |
---|---|
1 |
TRP0+ |
2 |
TRP0- |
3 |
TRP1+ |
4 |
TRP1- |
5 |
TRP2+ |
6 |
TRP2- |
7 |
TRP3+ |
8 |
TRP3- |
The following table summarizes the ToD/1-PPS port pinouts.
Pin |
Signal Name |
Direction |
Description |
---|---|---|---|
1 |
– |
– |
– |
2 |
– |
– |
– |
3 |
1PPS_N |
Output or Input |
1PPS RS422 signal |
4 |
GND |
– |
– |
5 |
GND |
– |
– |
6 |
1PPS_P |
Output or Input |
1PPS RS422 signal |
7 |
TOD_N |
Output or Input |
Time-of-Day character |
8 |
TOD_P |
Output or Input |
Time-of-Day character |
The following table summarizes the USB flash or MEM port pinouts.
Pin |
Signal Name |
Description |
---|---|---|
A1 |
Vcc |
+5 VDC |
A2 |
D- |
Data - |
A3 |
D+ |
Data + |
A4 |
Gnd |
Ground |
The following table summarizes the Console port pinouts.
Pin |
Signal Name |
Direction |
Description |
---|---|---|---|
1 |
Loop1 |
NA |
Loopback 1 |
2 |
Loop2 |
NA |
Loopback 2 |
3 |
TxD |
Output |
Console RS232 transmit |
4 |
Gnd |
NA |
Ground |
5 |
Gnd |
NA |
Ground |
6 |
RxD |
Input |
Console RS232 receive |
7 |
Loop2 |
NA |
Loopback 2 |
8 |
Loop1 |
NA |
Loopback 1 |
For more information on the supported power cables, see Ordering information for power cables supported on NCS 5700 on the Cisco Network Convergence System 5700 Router Data Sheet.