Cisco Spaces: Detect and Locate Configuration Guide

Bias-Free Language

The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.

Book Contents

Find Matches in This Book

Results

Updated:: November 6, 2024

Chapter: Data Source

Data Source
Configuring Location Data Source
- Configuring Location Data Source

Data Source

Configuring Location Data Source

You can configure any of the following as a source for location data:

Cisco Spaces Connector Configuration. Refer to Cisco DNA Spaces Connector Configuration Guide
Cisco AireOS Wireless Controller configuration: You can configure the Detect and Locate using wireless controller as data source. For more information, see Configuring Cisco Wireless Controllers and Cisco Catalyst 9800 Series Controllers for Cisco DNA Spaces
Cisco CMX tethering: With the Cisco CMX as a data source, location computation for wireless devices is calculated using Cisco CMX. Cisco Spaces: Detect and Locate displays wireless clients and tags.

Was this Document Helpful?

Feedback

Contact Cisco

Open a Support Case
(Requires a Cisco Service Contract)