This section describes how to add a system.

After installation, use this procedure to set up your Policy Builder by using an example populated with default data. You can change anything that does not apply to your deployment.

1. Click the Reference Data tab, and then click the Systems node to display the Systems tree.

2. Click System... under Create Child: to open the System pane on the right side.

3. Fill in the Name field, and provide a description of this system. Enter the rest of the parameters based on your network requirements.

   Table 3. System Parameters

   Parameter	Description
   Name	The name of the PCF system.
   Description	Describes the system using which you can uniquely identify the system.
   Session Expiration Hours	An event occurs whenever a session is updated, which in turn increments the session expiry duration. If no session update event occurs in the specified session expiration duration (combination of Session Expiration Hours and Session Expiration Minutes), then the session will be removed. Note  The combined value of Session Expiration Hours multiplied by 60 plus Session Expiration Minutes should not exceed 35,400 minutes. Default value is 8.
   Session Expiration Minutes	An event occurs whenever a session is updated, which in turn increments the session expiry duration. If no session update event occurs in the specified session expiration duration (combination of Session Expiration Hours and Session Expiration Minutes), then the session will be removed. Note  The combined value of Session Expiration Hours multiplied by 60 plus Session Expiration Minutes should not exceed 35,400 minutes. Default value is 0.