Configure Link Layer Discovery Protocol Using CTC

Enable LLDP on NCS4K-4H-OPW-QC2 Card using CTC

Purpose

This procedure describes how to enable LLDP on NCS 4000 using CTC that allows to learn the information of its peer devices connected through the Ethernet over OTN port.

Tools/Equipment

None

Prerequisite Procedures

"Login to CTC" in System Setup and Software Installation Guide for Cisco NCS 4000 Series

Required/As Needed

As needed

Onsite/Remote

Onsite

Security Level

Provisioning or higher

Procedure


Step 1

In the node view, click Provisioning > Network > LLDP.

Step 2

Select the LLDP check box.

Step 3

Click Apply.


View Neighbor Device Details Using CTC

Purpose

This procedure enables you to view the details of the neighbor devices connected to NCS 4000 through the Ethernet over the OTN port using CTC.

Tools/Equipment

None

Prerequisite Procedures

"Login to CTC" in System Setup and Software Installation Guide for Cisco NCS 4000 Series

Required/As Needed

As needed

Onsite/Remote

Onsite

Security Level

Provisioning or higher

Procedure


Step 1

In the node view, click Maintenance > Network > LLDP.

Step 2

Perform one of the following:

  1. Click the Neighbor tab to view neighbor devices.

  2. Click the Neighbor Details tab to view details of the neighbor devices.

Step 3

Click Refresh to refresh all the details in the tab.