Migrate from NCS4K-ECU to NCS4K-ECU2
Purpose |
This procedure provide instructions to migrate from NCS4K-ECU to NCS4K-ECU2 using CTC. |
Tools/Equipment |
None |
Prerequisite Procedures |
"Login to CTC" in System Setup and Software Installation Guide for Cisco NCS 4000 Series. |
Required/As Needed |
As needed |
Onsite/Remote |
Onsite |
Security Level |
Provisioning or higher |
Note |
Do not perform router or route processor reload during the migration procedure. |
Note |
To check the current status of migration while performing this procedure, click the Status button. |
Note |
You can check the alarm(s) and alarm state in the Alarms tab of CTC. |
Procedure
Step 1 |
In the Node View, click the Maintenance > ECU Upgrade tab. |
||
Step 2 |
Click the Detach button. |
||
Step 3 |
Click the Yes button. |
||
Step 4 |
Wait for the alarm The Detach Operation for disk started to clear.
|
||
Step 5 |
Remove the NCS4K-ECU unit physically form the chassis and replace it with the NCS4K-ECU2 unit.
|
||
Step 6 |
Wait 2-3 minutes, for the newly installed ECU unit to initialize. |
||
Step 7 |
Check to ensure that the ECU Plugged out alarm has cleared.
|
||
Step 8 |
Click the Attach button. This will trigger the attach procedure and The attach provision for disk started alarm will be raised. |
||
Step 9 |
Wait for Disk Provision and The attach provision for disk started alarms to clear. Once above alarms are cleared from the system, ECU migration from NCS4K-ECU to NCS4K- ECU2 is completed successfully. Stop. You have completed this procedure. |