show asngw-service all
Field | Description |
---|---|
Service name |
The ASN GW service name. |
Context |
The context in which the service is configured. |
Bind |
The bind status. |
Max Subscribers |
The maximum number of subscribers. |
IP address |
IP address of ASN GW server where this service is located. |
UDP Port |
The UDP port number. |
Service Status |
Status of this service. |
Authentication |
|
Policy msid-dhcp-chaddr-mismatch |
The status of the policy to handle the calls with mismatched DHCP Client Hardware (MAC) Address (CHADDR) and MSID of the ASN-GW session. |
Policy ms-unexpected-network-reentry |
The status of the policy to handle the unexpected network re-entry of an MS. |
Policy asngw-initiated-reauth |
The status of the policy to handle the ASN GW initiated reauthorization trigger. |
Policy non-anchor-mode |
The status of the policy to handle the ASN GW to accept the session in non-anchor mode. |
Newcall Policy |
|
Policy Overload |
|
Mobile IP FA context |
The name of the context where MIP FA service is configured. |
Maximum number of retransmissions |
The maximum number of retransmissions. |
Retransmission timeout |
The retransmission timeout duration. |
Setup timeout |
The session setup timeout duration. |
Active-relay timeout |
The timeout duration for active relay of R4 or R6 messages. |
Handover anchor data-path termination timeout |
The timeout duration in seconds to keep the data path registration with previous anchored BS after completion of handover. |
Handover anchor data-path pre-registration termination timeout |
The timeout duration in seconds to keep the data path pre-registration termination information with anchored BS after completion of handover. |
Handover non-anchor data-path termination timeout |
The timeout duration in seconds to keep the data path registration with non-anchored BS after completion of handover. |
Handover non-anchor data-path pre-registration termination timeout |
The timeout duration in seconds to keep the data path pre-registration termination information with non-anchored BS after completion of handover. |
Handover max number of data-path pre-registrations |
The maximum number of data paths created during pre-registration for a handover. |
Idle-mode entry timeout |
The timeout duration in seconds for a session to enter the idle mode from active mode. |
Idle-mode exit timeout |
The timeout duration in seconds for a session to reenter the active mode from idle mode. |
Idle-mode timeout |
The total timeout duration in seconds. |
Policy transaction-id-validation |
The status of the policy to validate the transaction id. |
Policy zero-function-type |
The status of the policy to allow the zero function type of call. |
Transaction Id. Seed |
The transaction identifier seed. |
Peer ASNGW addresses |
The IP addresses of trusted ASN GW peers for handover. |
BS Monitor Config |
|
Interval |
The configured amount of time in seconds between two ICMP ping message to an ASN BS. |
Timeout |
The number of seconds to wait for response from the ASN BS before re-sending the ICMP ping message. |
Number of retries |
The number of retries to sent ICMP ping messages to an ASN BS before the ASN BS is declared as dead/unreachable. |
MTU size |
The maximum transmission unit size configured in bytes. |
Total BSs |
The total number of BSs monitored. |
Active BSs |
The number of active BSs. |
Alive BSs |
The number of active and alive BSs. |
ICMP Monitored BSs |
The number of BSs which are monitored through ICMP ping messages. |
Inactive BSs |
The number of inactive BSs. |
No Calls BSs |
The total number of BSs which have no active calls or in idle mode. |
Going Down BSs |
The total number of BSs which are going down or terminating sessions. |
BS |
The IP address of BSs. |
Status |
The status of listed BSs. |
Maximum Number of Secondary IP Hosts |
The maximum number of secondary hosts connected behind a primary WiMAX CPE under multiple IP host support. |
Ran Peer Map Name |
The name of the RAN Peer Map this service is using to reconcile base station MAC address received in R6 protocol messages to the actual IPv4 address of the base station. |