show gtpu-service { name | all }
| Field | Description |
|---|---|
|
Service name |
The name of the service configured in the named context. |
|
Context |
The name of the context where the service is configured. |
|
State |
The status of the service, i.e., "Initiated". |
|
Echo Interval |
The duration between the sending of GTP-U echo messages. |
|
Sequence Number |
Identifies if the sequence number is added to every GTP-U packet. |
|
Include UDP Port Ext.Hdr |
Indicates if an extension header, in the GTP-U packet header, allowing for error indication messages will be added. |
|
Max-retransmissions |
The number of user data packet request message retransmissions that can be sent before an error condition is established. |
|
Retransmission Timeout |
The number of seconds between the re-sending of GTP-U echo messages |
|
IPSEC Tunnel Idle Timeout |
The number of seconds an IPSec tunnel is idle before tunnel deletion is triggered. |
|
Allow Error-Indication |
Indicates if the error indication will be allowed or suppressed upon the receipt of a user data packet for a non-existent session. |
|
Address List |
Identifies the IP address used to transmit/receive GTP-U packets. Also indicates, if configured, the type of bearer traffic to be associated with the bind address (non-ims media only, ims-media only or all). |
| GTPU UDP Checksum |
Indicates if the UDP checksum in UPD header of GTP-U packet is enabled/disabled and if it is optimized. Possible values are:
|
|
Path Failure Detection on gtp echo msgs |
Identifies if the path failure detection is enabled upon reaching the maximum number of echo retransmissions. |
|
Path Failure Clear Trap |
Identifies the configuration of the path-failure clear-trap command. Echo indicates that the path-failure trap will be cleared only on receipt of an echo message from the particular peer. Non-echo indicates that the path-failure trap will be cleared on receipt of the first control plane message for that GTPU peer allocation. |
|
GTPU Source-port Configuration |
: Use Standard Port |
|
GTPU Source-port Offset |
The offset configured for the GTPU source port. |
|
GTPU Peer Statistics Threshold |
The maximum number of GTPU peers supported. The default value is 16000. |
Feedback