show quality-of-service-profile

This chapter describes the output of the show quality-of-service-profile command.

show quality-of-service-profile full name

Table 1. show quality-of-service-profile full name Command Output Descriptions
Field Description

QoS Profile Name

Displays the name of the QoS Profile.

Description

Displays the description of the QoS Profile.

Preferred Traffic Class

Displays the configured preferred traffic class. The preferred traffic class can be:

  • Background
  • Conversational
  • Interactive
  • Streaming

Quality of Service Capping

Prefer Type

Displays the configured preferred type of Quality of Service capping, the preferred type can be:

  • Subscription and Local
  • Subscription
  • Local

Traffic Class

Displays the configured Traffic Class, the configured Traffic Class can be:

  • Background
  • Conversational
  • Interactive
  • Streaming

Sdu delivery order

Displays if the SDU delivery order is specified or not.

Delivery Of Erroneous Sdus

Displays if delivery of erroneous SDUs is configured or not.

Max Bit Rate Uplink

Displays the configured Maximum Kbps rate for the uplink direction.

Max Bit Rate Downlink

Displays the configured Maximum Kbps rate for the downlink direction.

Allocation/Retention Priority

Displays the configured Allocation/Retention priority.

Guaranteed Bit Rate Uplink

Displays the Guaranteed Kbps rate for the uplink direction.

Guaranteed Bit Rate Downlink

Displays the Guaranteed Kbps rate for the downlink direction.

Sdu Max Size

Displays the maximum number of octets (size) of the SDU

Minimum Transfer delay

Displays the configured Minimum transfer delay.

Sdu Error Ratio

Displays the configured SDU error ratio.

Residual BER

Displays the configured residual bit error rate.

QoS APN-AMBR

Max uplink

Indicates the aggregate maximum bit rate (AMBR) for uplink (subscriber to network) traffic.

Max downlink

Indicates the aggregate maximum bit rate (AMBR) for downlink (network to subscriber) traffic.

Sending of epc-qos-params to GGSN

This parameter is used to verify the configuration for EPC QoS support on SGSN. The epc-qos-params-in-gtpv1 command is used to enable or disable the SGSN to send EPC QoS parameters to GGSN. On enabling this command E-ARP and APN-AMBR parameters are included in the GTPV1 SM messages towards the GGSN. The parameter Enabled with GPRS Subs is displayed if the keyword gprs-subscriptio n is selected in the epc-qos-params-in-gtpv1 command.

Operator Defined QCI

Indicates if the Operator Specific QCI values are enabled or disabled.